How a home biogas toilet works

Toilet and kitchen scraps in, cooking gas and garden fertiliser out — Australian context
Slurry & digestate Biogas Mode: Making gas — the bag fills up
Simplified diagram, not to scale. Biogas, plumbing and gas work must be designed, approved and installed to local council rules by a licensed plumber and gas fitter.

Where the numbers come from

Every figure is a typical estimate from the published sources below (all links open in a new tab). Gas yields are eventual — they build up over weeks of digestion once the digester is established, not instantly. The burner, kettle and generator rows in the panel are alternative uses of the same gas, never additive.

Sanitation reality check: digestate is not automatically a safe fertiliser — it needs approved post-treatment and use must follow local health rules (never on food eaten raw). Ordinary full-flush toilets can over-dilute a small digester like this, which is why the diagram shows a low-flush, professionally designed setup. This page is a conceptual explanation, not DIY instructions — real systems must be designed, approved and installed by licensed professionals.

Constant usedValue & basisSource (fetched)
Food scraps yield0.119 m³ biogas per kg wet — measured mean of plants treating primarily kitchen waste; a plant figure, not a guaranteed household yield. (Upper reference: 0.65 m³/kg TS × 25% solids = 0.163 m³/kg wet, explicitly derived by Bhatt & Tao.) Wales AD Centre review, 2007
Bhatt & Tao, NREL, 2020
Excreta yield0.045 m³/kg wet — exact midpoint of the fetched 0.02–0.07 m³/kg. That figure is a daily production rate under continuous, established feeding; each click is an allocation from a representative day of steady feeding, not a measured per-batch ultimate yield, and it is never multiplied by retention days. Cool-climate performance is uncertain. Oxfam TBN 21 (WASH transcription)
Per flush / per person-dayAdult excreta ≈ 1.15 kg urine + 0.30 kg faeces = 1.45 kg/day → ≈0.065 m³/person-day. WELS usage (1 full + 4 half flushes/day) → 0.29 kg per average flush → ≈0.013 m³. One average flush is an assumed 1/5 of a person-day — a daily-average illustration, not an event-specific measurement; flush water earns no gas. Oxfam TBN 21 · WELS
Garden wasteNo gas credit. No verifiable wet-basis home-scale yield could be sourced; woody material is unsuitable (lignin; scum/pipe blockage) — compost instead. Soft green mass is still counted. IEA Bioenergy Task 37, 2011
Biogas energy6.0 kWh per m³ of biogas (chemical energy, ~60% methane; representative midpoint of the 50–70% band). Oxfam TBN 21 · Bhatt & Tao
Burner efficiency54.3% of the gas energy into the water — measured water-boiling test. From one small study; treat as a typical estimate. Abubakar, 2025
Kettle efficiency87.5% — midpoint of the fetched 85–90% span (own measurements 85%; other studies up to 90%). Gallego-Schmid et al., 2018
Generator efficiencyAssumed 30% — midpoint of the 25–35% small-CHP literature band. A hypothetical assumed efficiency, not measured 1 kW product performance; real sub-kW units are often worse. Your chosen kW is a scenario input. Gandiglio et al., 2017
Water4.186 kJ per kg per °C; boiling 100 °C (sea level). Litres boiled = gas kWh × 0.543 × 3600 ÷ (4.186 × (100 − start °C)). Stanford Physics

Formulas

Excluded values

A widely quoted grass yield of 70.23 m³/t wet (Radboud repository) could not be re-fetched for verification, and the 1991 Chandra burner paper was available only as a blocked abstract — neither is used. The 2023 Donacho human-faeces figure (0.393 m³ CH₄/kg) is on ~75%-dry samples, not fresh wet mass, so it is not used as a wet-basis input either.